Kia EV6 2024 Owner's Manual page 180

Features of your vehicle
known status of the garage door
for a few seconds.
3) Recalling Garage Door Status
HomeLink mirror with Two-Way Com-
munication provides a way to view the
last stored message from the garage
door opener. In order to recall the last
known status of the last activated
device, press the buttons "1 and 2" OR "2
and 3" simultaneously.
僅 If the indicator (4) appears solid
Green, it indicates that the last acti-
vated device was "closed" properly.
僅 If the indicator (6) appears solid
Green, it indicates that the last acti-
vated device was "open" properly.
3. Erasing HomeLink씾 Buttons
1) Erasing and Reprogramming a
Single HomeLink씾 Button:
1. Press and hold the desired HomeLink
button you want to re-program. DO
NOT release the button.
2. The HomeLink indicator light (7) will
appear solid green. Release the but-
ton as soon as the HomeLink indicator
light (7) begins to flash orange, usu-
ally about 20 seconds.
3. Proceed with the steps in the "Pro-
gramming a New HomeLink Button"
section.
NOTICE
If you do not complete the re-program-
ming of a new device to the button, it will
revert to the previously stored program-
ming.
5 54
2) The following instructions will
erase ALL HomeLink씾 program-
ming from ALL buttons:
OCV041609N_2
1. Press and hold the buttons (1) and (3)
simultaneously
2. The HomeLink indicator light (7) will
appear solid Orange for about 10 sec-
onds
3. Release the buttons once the Home-
Link indicator light (7) changes to
Green and flashes rapidly
4. Now all three HomeLink buttons (1),
(2) and (3) are cleared of any pro-
gramming
Information
HomeLink and the HomeLink House
logo are registered trademarks of Gen-
tex Corporation.
The myQ logo is a registered trademark
of The Chamberlain Group, Inc
FCC (USA) and ISED (Canada)
This device complies with FCC rules part
15 and Innovation, Science, and Eco-
nomic Development Canada RSS-210.
Operation is subject to the following two
conditions: (1) This device may not cause
harmful interference, and (2) This device
must accept any interference that may
be received including interference that
may cause undesired operation. WARN-
ING: The transmitter has been tested
and complies with FCC and ISED rules.
Changes or modifications not expressly
approved by the party responsible for
Mirrors
OwnersManuals2.com