Changing The Saw Bar; Sawing Techniques; General - Parkside Performance PPKSA 40-Li A1 Translation Of The Original Instructions

If no oil trace can be seen clean the
oil passages or turn the chainsaw
to our Service-Center for repair.
Clean the oil passages of the chain
bar­(28),­in­order­to­guarantee­a­
trouble-free,­automatic­oiling­of­the­
saw chain during operation. Use
a brush or a cloth to help remove
residues from the oil outlet duct.

Changing the saw bar

1. Switch off the device and remove the
16)­from­the­device.
batteries (
2.­ Lay­the­saw­on­a­flat­surface.
3.­ Turn­the­fastening­bolt­(11)­and­the­
screw for the chain quick-tensioning
system­(12)­in counter-clockwise
direction in order to loosen the chain
tension and to remove the sprocket
chain­wheel­cover­(13).
4.­ Remove­the­saw­bar­(4)­and­saw­chain­
(6).­To­remove­the­guide­bar­(4),­raise­
it­to­an­angle­of­approx.­45­degrees.­
This will make it easier to take the saw
chain­(6)­off­the­sprocket­ (20).
5. Replace the blade and install the blade
and chain as described under "Install-
ing­the­sawing­chain­and­blade".
Approved blade bars:
Oregon­164MLE041(112329),
Trilink M1431656-1041TL.
Refer to the start-up section on how
to tension the saw chain.

Sawing techniques

General

Observe the noise protection and
local regulations when cutting
wood. Local requirements may
require a suitability test. Ask the
forestry commission.
•­ Dirt,­stones,­loose­bark,­nails,­staples­
and wire must be removed from the tree.
•­ For­sawing­work­on­a­slope,­always­
stand above the tree trunk.
• To keep control at the moment of
"sawing­through",­reduce­the­contact­
pressure at the end of the cut without
loosening­the­firm­grip­on­the­chainsaw­
handles.­Ensure­that­the­saw­chain­does­
not come into contact with the ground.
•­ After­completing­the­cut,­wait­for­the­
chainsaw to come to a standstill before
removing the chainsaw.
• Always switch off the chainsaw motor
before moving from one tree to another.
• Lay the connecting lead such that it will
not be caught on branches or similar
during sawing.
•­ For­each­cut,­apply­the­claw­stop­se-
curely and only then start sawing.
• You have better control when you saw
with the bottom side of the chain bar
(with­pulling­saw­chain)­and­not­to­with­
the top side of the chain bar (with push-
ing­saw­chain).
• The saw chain must not contact either the
ground or another object during sawing
through or after sawing completion.
• Make sure that the saw chain does not
become jammed in the wood. Do not
let the tree trunk break or split off.
• Consider also the precautions against
spring-back­(see­notes­on­safety)..
GB MT
53