Removing/Inserting The Rechargeable Battery; Operating; Switching On - Parkside Performance PPKSA 40-Li A1 Translation Of The Original Instructions

Filling up with chain oil:
•­ Check­the­oil­fill­level­and­regularly­top­
up­with­oil­(10)­when­the­„minimum­
mark" is reached.
The­"minimum­mark"­is­the­lower­
line­of­the­oil­level­indicator­(10).­
The oil tank holds 180 ml of oil.
• Use a chain oil with a low content of
adhesive additives.
Chain oil and bio chain oil with addi-
tives to reduce friction and wear can
be purchased from our online shop.
•­ Empty­the­oil­tank­before­longer­peri-
ods­(6-8­weeks)­of­non-use.
1.­ Unscrew­the­oil­fill­cap­(9)­and­
fill­up­with­chain­oil.
2. Wipe off any spilled oil and
close the cap again.
Always switch off the device
and allow the motor to cool
before filling with chain oil.
There is a risk of fire if oil
overflows.
Removing/inserting the
rechargeable battery
1.­ To­insert­the­batteries­(16)­into­the­de-
vice,­push­the­batteries­along­the­guide­
rails­(23)­into­the­device.­You­will­hear­
them click into place.
2.­ To­remove­the­batteries­(16)­from­the­
device,­press­the­release­button­
16a)­on­the­batteries­and­pull­the­
(
batteries out.

Operating

Switch on the chainsaw only when
chain­bar,­saw­chain­and­sprocket­
chain wheel covering are correctly assem-
bled.
Make sure you have a secure stance. Be-
fore­starting,­ensure­that­the­electric­chain-
saw is in contact with no objects.
­ Caution!­Saw­can­oil­up,­see­notes­
on Operation startup.

Switching on

The device may only be used with
two batteries of the X 20 V Team
series from Parkside.
1.­ Place­the­batteries­(16)­into­the­device­
(see "Inserting/removing the recharge-
able­battery").
2.­ Check­before­the­start,­
-­ whether­sufficient­chain­oil­is­in­the­
tank­and,­if­necessary,­refill­with­
chain oil (see Chapter Operation
Start).
- the charge level of the batteries.
3.­ Release­the­chain­brake,­where­you­
shift­the­brake­arm­(5)­back­against­the­
front­grip­(4).
4.­ Hold­the­chainsaw­firmly­with­both­
hands,­with­the­right­hand­on­the­rear­
grip­(1)­and­the­left­hand­on­the­front­
handle­(4).­Thumb­and­finger­must­
close securely over the handles.
5.­ To­start­the­device,­push­the­switch­lock­
(3)­forwards­with­the­right­thumb­and­
press­the­on/off­switch­(2).The­device­
starts at the last selected chain speed
level.­Release­the­switch­lock­(3).
6. The power saw switches off when you
release­the­On/Off­switch­(2)­again.­
Switching for continuous running is not
possible.
GB MT
51