Settings; Introduction To Parameter Codes - REMEHA Gas 320 Ace Service Manual

Tab.35 Electrical connections to be bridged on CB-01
Producer Connection
B CB-01
(1)
BL
(1) Bridge: These connectors must be bridged. Some bridges are already factory-fitted, some need to be fitted for this specific installation
example.
Tab.36 Parameters to be set
Producer Connection
CU-GH13
(1)
AP102 = 0
CP020 = 0
DP007 = 0
(1) Parameters to be set: The parameters are separated per PCB, and must be set on that specific PCB.
Tab.37 Parameter list
Code Display text
AP102 Boiler Pump function
CP020 Zone Function
DP007 Dhw 3wv Standby
CP021 Zone Function
CP020 Zone Function
6

Settings

6.1

Introduction to parameter codes

Fig.46 Code on a HMI T-control
00:12 ...... ........ ....... ......
....................
..... ... ....... .... .. ..... ....
....... .... .. ..... ....
....... ........... CP010
..... ... ....... ....
..... ... ....... ....
..... ... ....... .... .. ..... ....... .... ..... .......
........ .......
Fig.47 First letter
7734325 - v.07 - 22092022
CH 1 / CircB 1
CH 1 / CircB 1
SCB-02
CP021 = 1
Menu path
> Installation Setup > CU-GH13 > Gas fired appliance >
Parameters, counters, signals > Parameters > General
> Installation Setup > CU-GH13 > CIRCA > Parameters,
counters, signals > Parameters > General
> Installation Setup > CU-GH13 > Internal DHW > Parameters,
counters, signals > Parameters > General
> Installation Setup > SCB-02 > CH 1 > Parameters, counters,
signals > Parameters > General
> Installation Setup > SCB-02 > DHW 1 > Parameters,
counters, signals > Parameters > General
The controls platform makes use of an advanced system to categorise
parameters, measurements and counters. Knowing the logic behind these
codes, makes it easier to identify them. The code consists of two letters
and three numbers.
.........
.......
...
......
.....
CP010
AD-3001373-02
The first letter is the category the code relates to.
CP010 A
C
AD-3001375-01
D
E
G
P
Category D codes are appliance controlled only. When the domestic hot
water is controlled by an SCB, it is handled like a circuit, with C-category
codes.
DHW 1
DHW 1
SCB-02
CP020 = 6
Appliance: Appliance
Circuit: Zone
Domestic hot water: Domestic hot water
External: External options
Gas fired: Gas-fired heat engine
Producer: Central heating
6 Settings
Set to
0 = No
0 = Disable
0 = CH position
1 = Direct
6 = DHW tank
31