Cleaning The Burner - REMEHA Gas 320 Ace Service Manual

Fig.80 Inspecting and cleaning the gas
filter
4
4.1
7.4.5

Cleaning the burner

Fig.81 Removing the burner
Fig.82 Checking and cleaning the burner
3
4
min. 1cm
2-5 bar
Fig.83 Checking the burner end cap
6
Fig.84 Cleaning the burner area
8
9
7734325 - v.07 - 22092022
4. Inspect the gas filter.
5. Reassemble the unit in reverse order.
4.2
AD-3001604-01
1. Unscrew the bolts from the adaptor and remove the adaptor.
2. Lift the burner out of the heat exchanger.
1
2
AD-3001578-01
3. Check the burner.
4. Clean the outside of burner using compressed air with a pressure of 2
5
5. Clean the inside of the burner using a vacuum cleaner.
AD-3001579-01
6. Check the burner end cap.
7. Set the burner aside, making sure it can not be damaged.
AD-3001580-01
8. Visually inspect the burner area.
9. Use a vacuum cleaner to remove any visible soiling from the burner
AD-3001587-01
4.1. Replace the gas filter if necessary.
4.2. Clean the gas filter without the use of liquids (shake it or
carefully blow it clean) if it does not need to be replaced.
to 5 bar.
Caution
Maintain a minimum distance of 1 cm from the surface of the
burner.
Never clean the burner's surface with a brush or similar item.
Replace the burner or end cap if faulty or seriously damaged.
Caution
Do not refit the burner until the heat exchanger, condensate
collector and siphon have been cleaned.
area.
7 Maintenance
69