Brush Pressure / Load Adjustment; Breakaway Floor Tool - Numatic NACECARE NX300 TTB3045NX Original Instructions Manual

Brush Pressure / Load Adjustment

1
3
TTB817NX/TTB817NX-R comes with one11kg weight (3). Place the Deck Pressure Weight into the machine before using (4).
For lightly soiled floors one 11kg weight would suffice, for heavily soiled areas the TTB817NX/TTB817-R has been designed to use
extra weight if needed (available as an optional extra).
Pressure 1 (Light)
Pressure 2 (Medium)
* Additional 11kg weight available as an optional extra.
Pressure 3 (Heavy)
Pressure 4 (Extra Heavy)
NOTE* Additional weight will decrease run time. The TTB817NX/TTB817NX-R has been designed to have no more then a Maximum of
two weights.
The floor tool design incorporates a break-away feature.
Allowing it to safely disengage from its mounting should it become caught on an obstruction,
during forward machine movement.
To re-attach the blade to its holder. First loosen the retaining knobs on the floor tool body and slide onto the holding bracket.
Tighten retaining knobs to finger tight.
2
4
1 x 11kg in weight location B
1 x 11kg in weight location A
2 x 11kg weights one location A and one in location B
2 x 11kg weights in position A (Stacked)
10
Pressure Weights
To obtain the best out of your TTB817NX/
TTB817NX-R Numatic have supplied
a 'Deck Pressure Weight' allowing the
operator to add or remove pressure on the
brush or pad for optimum performance on
all floor types.
B
Remove the Top (Waste Water) tank (1).
A
Set in the lower tank are location pillars (2)
to locate the Deck Pressure Weights (5).
5
B
Brush (gCM2)
24.52
29.14
31.63
35.54
Break-away Floor Tool
Using the Deck
A
Pad (gCM2)
25.28
30.05
32.61
36.64