Specifications; 12. Warranty - Numatic NACECARE NX300 TTB3045NX Original Instructions Manual

10. DISTRIBUTOR TAKE-BACK / DISPOSAL
On the basis of Battery Directive, the manufacturers take responsibility for fi nancing collection, treatment and recycling
•
of batteries used in devices. To this end, batteries must be handed over for disposal to the collection systems
established for this under national law. Disposal of batteries together with household waste is prohibited; batteries must
be collected separately according to type.
Return the battery free of charge to your NUMATIC servicing dealer for disposal or hand it over to an appropriate public
•
collection point.
11. CHARGING BATTERIES
The charger is intended for use only on fl at surfaces, place horizontally on fl oor or work surface. The charger is intended for use
•
with the detachable power cord supplied, the power unit is capable of operating at diff erent voltages without user adjustment. If
the charger is damaged or does not charge anymore, please return to service centre.
Charging Procedure:
Ensure the battery is fully inserted into the charger.
•
• Fit the mains power cord to charger and suitable power supply.
Please Note: If the battery is above its optimum charging temperature (due to ambient temperature or it if was recently discharged)
the charger LED will illuminate on/off RED for a maximum of 40 minutes whilst the battery temperature falls to an acceptable level for
charging to begin.
• The LED should show RED to indicate charging.
• Once fully charged the LED will show GREEN.
If power is supplied to the charger with no battery fi tted the LED will show GREEN to indicate STAND-BY status.
•
CAUTION!
Check the mains cord regularly for any sign of damage.
•
Do not use damaged devices.
•
If the mains cord of the charger is damaged, it must be replaced by an original NUMATIC INTERNATIONAL cord available from
•
the manufacturer or service agent.

12. WARRANTY

Warranty: Commercial Use
a. Batteries are warranted (3 Year) providing all battery care rules are followed
b. To claim warranty the following details must be supplied
i. Serial number of the machine
ii. Battery date code
iii. Date purchased
iv. Proof of Purchase
v. Maintenance history and charging regime
Failure to use the correct Numatic charger will void your warranty.
CLEANING AREA
BRUSH MOTOR POWER
BRUSH SPEED
BRUSH DIA
PAD DIA
VAC MOTOR MAX. POWER
VAC MOTOR - SUCTION @ SQUEEGEE
VAC MOTOR - AIRFLOW @ SQUEEGEE
WATER CAPACITY
WATER FLOW - AVERAGE
DRIVE MOTOR POWER/DRIVE SPEED
WATER INGRESS PROTECTION
Lithium-Ion Battery Warranty
TTB3045NX / TTB3045NX-R
13078ft²/HOUR
GROSS WEIGHT ( i.e. with liquid)
@ 1.67 mph
300W NETT WEIGHT ( i.e. NO liquid)
100 rpm POWER SOURCE
18" RUN TIME (BATTERY LIFE)
16" RECHARGING TIME
210W HEIGHT
155 mbar LENGTH
293.3 gpm WIDTH
8 gall SQUEEGEE LENGTH
31.7 gpm SOUND PRESSURE LEVEL
N/A VIBRATION LEVEL
IPX4 MAX GRADIENT
19

Specifications

240 lb
174.8 lb
2 x Lithium-ion 36V | 8400mAh | 300Wh |
65 MINS
1 HR to 80% - 2HR to 100%
43.3"
36" (42")
18.5" (31.7")
31.7"
LpA < 70 dB(A)
HAV < 8.20 ft/s²
2%