Brush Pressure / Load Adjustment; Breakaway Floor Tool - Numatic NX300 Original Instructions Manual

Brush Pressure / Load Adjustment

1
3
TTB.3045.NX comes with one11kg weight (3). Place the Deck Pressure Weight into the machine before using (4).
For lightly soiled floors one 11kg weight would suffice, for heavily soiled areas the TTB.3045.NX has been designed to use extra
weight if needed (available as an optional extra).
Pressure 1 (Light)
Pressure 2 (Medium)
* Additional 11kg weight available as an optional extra.
Pressure 3 (Heavy)
Pressure 4 (Extra Heavy)
NOTE* Additional weight will decrease run time. The TTB.3045.NX has been designed to have no more then a Maximum of two weights.
Machine Operation
Break-away Floor Tool
The floor tool design incorporates a break-away feature.
Allowing it to safely disengage from its mounting should it become caught on an obstruction, during forward machine movement.
To re-attach the blade to its holder. First loosen the retaining knobs on the floor tool body and slide onto the holding bracket.
Tighten retaining knobs to finger tight.
10
www.numatic.co.uk
2
4
1 x 11kg in weight location B
1 x 11kg in weight location A
2 x 11kg weights one location A and one in location B
2 x 11kg weights in position A (Stacked)
Using the Deck Pressure
Weights.
To obtain the best out of your TTB.3045.NX
Numatic have supplied a 'Deck
Pressure Weight' allowing the operator to
add or remove pressure on the brush or pad
B
for optimum performance on all floor types.
Remove the Top (Waste Water) tank (1). Set
in the lower tank are location pillars (2) to
A
locate the Deck Pressure Weights (5).
5
B
Brush (gCM2)
A
Pad (gCM2)
24.52 25.28
29.14 30.05
31.63 32.61
35.54 36.64