Setting The Cleaning Controls; Fill Level Indicator; Brush Pressure Adjustment - Numatic TRO 650/200T Owner's Instructions Manual

Setting the Cleaning Controls

Waste-water Tank Fill Level Warning Light
Brush pressure / Load adjustment
28
!
The run-time of the machine may decrease if the load on the brushes is increased.
Insert the key into the ignition and quarter-turn it clockwise to position (1) 'ON'.
The battery charge-level indicator will illuminate.
When the waste-water tank becomes full, a red warning light will
illuminate on the operator control panel (as illustrated) and the
vacuum motor will stop automatically.
The waste-water tank requires emptying (see page 16).
The machine is equipped with a brush-pressure load-warning system.
If the brush load increases due to changing floor types, the pressure can be
adjusted manually by the operator using the adjuster knob found on the left hand
side of the control column.
Turn it anti-clockwise to decrease load on the brushes and clockwise to increase
load/pressure on the brushes (see Fig.28).
Note: The run-time of the machine may decrease
if the load on the brushes is increased.
Note:
Machine Operation
T 01460 68600
!
11