Brush Pressure / Load Adjustment - Numatic TTV 5565 Owner's Instructions Manual

Brush Pressure / Load Adjustment

The brush load lever is located to the right hand side of the machine.
This option is for hard to clean patches, adding extra pressure to the brushes.
The brush load indicator on the control display shows the pressure applied, when the
machine is being operated.
30
(A) Standard Duty
17 Kg Pressure
(Fig.30)
NOTE: It is recommended this option is NOT used all the time and is for spot cleaning only.
The run-time of the machine may decrease if the load on the brushes is increased.
33
Setting the cleaning controls
31
A
Machine Operation
Waste-water Tank Fill Level Warning Light
When the waste-water tank becomes full, a red warning light will illuminate on the
operator control panel (as illustrated).
The vacuum motor will stop automatically after 5 seconds.
The waste-water tank requires emptying (see page 19).
Emergency Stop
The TTV 5565 is equipped with an electronic braking system.
Simply release the hand operated start / stop trigger and the machine will stop.
In an emergency, strike the Emergency Stop button.
The machine will be disabled.
To reset, turn Emergency Stop button clockwise (see Fig.33).
After re-setting the Emergency Stop button, to restart the machine, turn the main
control on / off key to '0' and then position '1'.
B
(B) Heavy Duty
30 Kg Pressure
(Fig.31)
15
32
(C) Extra Heavy Scrub
50 Kg Pressure
(Fig.32)
C