Machine In Use; Machine Maintenance - Numatic NACECARE NX300 TTB3045NX Original Instructions Manual

!
ALWAYS ENSURE THAT THE FLOOR IS

Machine In Use

PRE-SWEPT AND RELEVANT
SAFETY SIGNS ARE DISPLAYED.
To operate, set water flow rate tap, lower brush deck, lower the floor tool, press the vacuum / water switches, pull
brush On/Off trigger.
The waste water is then retrieved by the suction floor tool.
Overlap each scrubbing path by 4" to ensure an even clean.
Do not operate the machine on inclines that exceed (2%), when full.
On heavily soiled floors use a 'double scrub' technique.
First pre-scrub the floor with the floor tool in the raised position, allow the chemical time to work then scrub the area
a second time with the floor tool lowered.
If streaking occurs wipe floor tool blades clean.
Note: Care must be taken to reduce speed when cornering or when manoeuvring around obstacles
ALWAYS ENSURE THAT THE
MACHINE IS SWITCHED
!
OFF PRIOR TO ANY
MAINTENANCE REMOVE
BOTH BATTERIES PRIOR
TO ANY MAINTENANCE
OPERATION.
A
1
3
!
Regular Maintenance
!
After use, empty waste
water tank using emptying
A
hose and flush out with
clean water.
Next remove floor tool
vacuum hose and flush
B
out with clean water.
Next empty clean water
tank, using emptying hose
C
and again flush out with
clean water.
Whilst pressing in the top tank separator
toggles, remove the separator. (Fig.1)
The separator also has a sealing-rubber
which should be examined at every
clean-down.
Rinse using clean water, avoiding the vac
filter.
Remove the filter fitted into the separator
and flush with clean-water (Fig.2)
IMPORTANT
Remove vac filter and clean if required
(keep dry).
Never use the machine without the
recommended filter as it may cause
damage to the machine.
Remove debris basket filter and rinse
using clean water, and refit. (Fig.3)
IMPORTANT If the debris basket is
allowed to become clogged, vacuum
performance can deteriorate.
Located under the left hand side is a clean
water filter, make sure the clean water tank
is empty before removing this filter. (Fig.4)
Note: To make access easier, raise the
brush deck.
11
Machine In Use
B
C
2
4