TransAct BANKjet 1500 Operator's Manual page 16

2 2 2 2
$ $ $ $ < < < <
. + ( " $ $ ) " < $ )
( "" " $ $ ) " < $ )
. .( " $ $ ) " < $ )
! ", $ $ ) " < $ )
< ( ! ) ")"$ ( $ $ ) " < $ )
"$ ) ")"$ ( $ $ ) " < $ )
The descriptions below reflect the normal uses of the keypad indicator lights. These indicators are also used during
self-test and errors modes to convey additional information.
. 0 $ <
The
. + ( " $ $ ) " < $ )
( $ <
The
( "" " $ $ ) " < $ )
, along with the other indicators may be used to determine the cause of the problem.
< $ )
. $ <
The
. .( " $ $ ) " < $ )
supply has been exhausted, the printer will stop, and the
paper is reloaded, the indicator lights will be extinguished and the printer will resume operation. If the BANKjet
1500 is equipped with the optional paper low feature, the
diameter decreases below a preset minimum. This indication is a warning only, the printer will continue to operate
normally until the paper supply is exhausted.
! $
The
! ", $ $ ) " < $ )
the operator that the printer is waiting for a form to be inserted/removed in the printer. The
will change to a steady ON condition when a form is present in the printer.
< % "
The printer has two ink cartridge indicator lights that display the status of the ink cartrides. The indicator light will
blink slowly when the ink level in the respective cartridge falls below a preset, programmable level. It is a warning
only, the printer will continue to operate without intervention. When ink cartridge(s) are removed, or the ink
cartridge is defective, the corresponding light will blink at a faster rate. Printer operation is inhibited until the
cartridge is replaced.
Revision E
Indicates printer activity and non-recoverable errors.
Indicates problems and probability of recovery.
Indicates paper status (paper low and paper out).
Indicates validation/inserted form status
Indicates ink levels of left cartridge.
Indicates ink levels of right ink cartridge.
C <( D
becomes active when the printer is in the OPERATIONAL/ON mode.
C < ( D
becomes active when a problem is detected by the printer. The
C < ( D
is used to communicate the amount of paper remaining in the printer. When the paper
is used during form validation operations. The
$ < C < ( D
and
. .( " ( "" " $ $ ) " < $ )&
. .( " $ $ ) " < $ )
! ", $ $ ) " < $ )
( "" " $ $ ) "
will illuminate. When
will flash when the paper roll
blinks to alert
! ", $ $ ) " < $ )
B