TransAct BANKjet 1500 Operator's Manual page 38

2 2 2 2
. . . . . . . . $ & % $ & % 7 7 7 7 ) $ & % $ & %
The ( + ")"$ ( Button may be used to enter the BANKjet's self-test mode. To place the BANKjet in self-
test mode, be sure that a paper roll is loaded. The
place the printer in self-test mode.
1. Press and release the * Button to switch the printer into STANDBY/OFF mode. (The
will be not be illuminated.)
2. Press and hold the (+
3. While holding the ( +
4. When the red,
( "" " $ $ ) " < $ )
5. Follow the directions printed on the receipt to cycle through and select the desired TEST option.
( A ( A ( A ( A & % 7 7 7 7 ) & % & % & % ) ) ) , , , ,
Exit Self-Test mode at any time by pressing the * Button to place the printer back into OPERATIONAL/ON mode.
& % 7 7 7 7 ) & % & % & % ) ) ) & & & &
If the printer fails to complete or enter into self-test mode, disconnect it from the application system.
•
Contact TransAct's Ithaca Facility's Technical Support Department if self-test mode fails in any way.
•
Revision E
) ) ) , , , ,
. + ( " $ $ ) " < $ )
")"$ ( Button.
")"$ ( Button, press and release the * Button.
blinks, release the ( +
should not be illuminated when trying to
. + ( " $ $ ) " < $ )
")"$ ( Button.
;