Strymon ULTRAVIOLET vintage vibe User Manual page 22

Configuring UltraViolet to Use MIDI
STEP 3 – SET MIDI OUT MODE
1
Press and hold the footswitch for at least 2 seconds while powering
up UltraViolet� Once the LED flashes RED, release the footswitch�
2 Turn the INTENSITY
data is sent from UltraViolet to other MIDI devices� The LED will flash
momentarily to indicate your selection�
• OFF: RED
UltraViolet�
• THRU: BLUE
the MIDI Out without any additional MIDI messages generated by
UltraViolet�
• SEND CC, OTHER:
messages generated by UltraViolet are sent to the MIDI Out�
• SEND OTHER:
by UltraViolet are sent to the MIDI Out�
3 Press the footswitch to store the MIDI Out Mode and exit�
NOTE: MIDI data is sent from the RING of the TRS connection of the EXP/
MIDI jack�
blend
chorus vibrato
MODE
SPEED
(MIDI OUT) knob to select what kind of MIDI
(default, minimum) - No MIDI messages are sent out of
(11 o'clock) - Incoming MIDI messages are sent to
GREEN
AMBER
(maximum) - Sysex messages generated
(continued)
mid
low high
BIAS
INTENSITY
MIDI OUT
VOLUME
vintage vibe
(1 o'clock) - MIDI CC and Sysex
pg 22