Bypass Modes; True Bypass - Strymon DECO User Manual

Deco
- Tape Saturation & Doubletracker User Manual

Bypass Modes

Deco is set up for True Bypass from the factory. To change this mode,
hold down both Saturation Bypass and Doubletracker Bypass switches
while powering up. While holding down, turn the Blend knob to one of two
ranges shown below.

TRUE BYPASS

Set here to use our True
Bypass circuit, which is simply
a mechanical relay to switch
the input signal directly to
the output, with absolutely no
components attached.
Set here to use our high-quality Analog Buffered
Bypass. This circuit features a 1Meg input
impedance, keeping the character of your guitar
pickup unaltered. The output impedance is 100
Ohms and can drive hundreds of feet of cable
without coloring your sound.
HOLD BOTH AT POWER UP while turning the
BLEND knob to set Bypass Mode
BUFFERED BYPASS
®
pg 8