Starting And Stopping The Pump - SIMS Deltec CADD-1 5100 HFX Operator's Manual

3.8

Starting and Stopping the Pump

To start the pump, follow these steps:
Press and hold the STOP/START key. Three dashes appear
STEP 1:
on the display; then they disappear one-by-one.
Release the STOP/START key after the last dash disappears, and the
STEP 2:
pump beeps; then the word "STOP" disappears from the display, and all
of the programmed modes appear for your review one after the other.
To stop the pump, follow these steps:
Press and hold the STOP/START key. Three dashes will
STEP 1:
appear one-by-one on the pump's display.
After the third dash appears, release the
STEP 2:
STOP/START key. The word "STOP"
will flash on the display. In this example, the
display shows a RES VOL value of 28 ml.
28
---
---
028
RES VOL
*
STOP
⁄
⁄
ML