Starting And Stopping The Pump - SIMS Deltec CADD-PLUS 5400 Operator's Manual

3.8

Starting and Stopping the Pump

To start the pump, follow these steps:
STEP 1: Press and hold the STOP/START key. Three dashes appear
on the display; then they disappear one-by-one.
STEP 2: Release the STOP/START key after the last dash disappears, and the
pump beeps; then the word "STOP" disappears from the display. All of
the programmed modes appear for your review one after the other.
To stop the pump, follow these steps:
STEP 1: Press and hold the STOP/START key. Three dashes will
appear one-by-one on the display.
STEP 2: Release the STOP/START key after the
third dash appears. The word "STOP"
will flash on the display. In this example,
the display shows a RES VOL value of
28 ml.
38
⁄
---
⁄
---
*
028
RES VOL
STOP