Ordering Replacement Parts - enphase IQ7+ Installation And Operation Manual

Microinverters

Hide thumbs Also See for IQ7+:

Installation and operation manual (41 pages)

Quick install manual (5 pages)

Installation and operation manual (42 pages)

Table Of Contents

Table of Contents

J. Add the new microinverter serial number to the IQ

number. Perform the following steps:

Open the Enphase Installer App.

2. Select your site name.

3. Connect your mobile device to the IQ Gateway via AP mode.

4. Go to Devices & Array.

5. Open IQ Microinverters & Array.

6. Click on Scan IQ Microinverter.

7. Scan the barcode of the microinverter.

8. After scanning, move to IQ Gateway Connectivity and provision the device.

K. Add the new microinverter serial number to the IQ

using one of the following methods:

a. Method 1: Initiate a scan using the Enphase Installer App

1. In the Enphase Installer App, navigate to the Overview screen once connected to the IQ

Gateway Metered.

2. From the Overview screen, tap Devices & Array > Start Device Scan to start a new 30-

minute device scan.

3. If device scanning on the IQ

you need to add more microinverters to the system when device scanning is inhibited on the

IQ Gateway Metered, you must use the Enphase Installer App scanning tool to provision

them on the IQ Gateway Metered rather than using the IQ Gateway Metered's device

scanning function to discover them. If this is not possible and you need to enable device

scanning on the IQ Gateway Metered, contact

b. Method 2: Use an IQ Gateway Metered

Press the Device Scan button on the IQ

15-minute scan to identify all the microinverters deployed at the site. The Microinverter

Communications LED

L. Log in to the Enphase Installer App to use the Enphase Installer App's array builder to add the newly

detected microinverter to the virtual array.

M. Ship the old microinverter to Enphase using the supplied return-shipping label.