12. UNIT ASSEMBLING
If unit is with integrated control system, cable connectors must be connected between sections:
• Place unit section close to each other (approximately 0,2 m).
• Connect cable connectors.
• Every cable connector marked with numeric label.
• Connectors must be connected in accordance with their numbers. Connectors cannot be mixed.
• Connect unit sections together.
Figure 12.1 – Cable connection between sections
Figure 12.2 – Connector with numeric label
Sections of the device must be connected/disconnected in accordance with the safety requirements. If not observed, device can be damaged.
EIOM v2018.04
EN |
35