Connection Diagram; Connection Of The Unit To Electric Network - Salda VEKA INT EKO Series Mounting And Installation Instruction

D2 dimensions depend on unit.

15. CONNECTION DIAGRAM

Fig. 15.3. Indication for duct connection.
LIST OF COMPONENTS
PV Supply air fan
KE1
Electric heater
PF
Supply air filter
M2
Outdoor air damper actuator
M5
Water cooler valve motor
M6
Water heater valve actuator
POSSIBLE PCB INPUTS/OUTPUTS
System mode switch (START/STOP)
* Component/posibility to connect it depends on model. For more information please, check the manual

16. CONNECTION OF THE UNIT TO ELECTRIC NETWORK

• Supply voltage to the unit must be connected by a qualified specialist following the manufacturer's instructions and effective safety instructions.
• The unit's power network voltage must correspond to electrotechnical parameters of the unit indicated in the technical decal.
10 | SE
Fig. 14.2. Rectangular air duct conection
Fig. 15.1. VEKA INT W EKO (* Placement of the component depends on model)
Fig. 15.2. VEKA INT E EKO (* Placement of the component depends on model)
ODA - outdoor air; SUP - supply air.
PS
PS
Fig. 15.4. Ventilated premises
TL Outdoor air temperature sensor
TJ
Supply air temperature sensor
CO
CO sensor*
2 2
M4
Water heater circular pump
RC1
Stouch, Flex or SA-Control remote control panel
TV1
Fans speed switch (BOOST)
PS
M
PS
PS
PS
CO
2
VEKA INT EKO v2019.05