Mounting The Profiled Seal For The Universal Process Adapter; Post-Installation Check - Endress+Hauser Cerabar PMP11 Operating Instructions Manual

Cerabar PMP11, PMP21, PMP23
Endress+Hauser
5.4.2 Level measurement
• Always install the device below the lowest measuring point.
• Do not install the device at the following positions:
– In the filling curtain
– In the tank outlet
– In the suction area of a pump
– Or at a point in the tank which could be affected by pressure pulses from the agitator.
5.5 Mounting the profiled seal for the universal process
adapter
For details on mounting, see KA00096F/00/A3.
5.6

Post-installation check

 Is the device undamaged (visual inspection)?
Does the device conform to the measuring point specifications?
For example:
• Process temperature

• Process pressure
• Ambient temperature range
• Measuring range
 Are the measuring point identification and labeling correct (visual inspection)?
 Is the device adequately protected from precipitation and direct sunlight?
 Are the securing screws tightened securely?
Installation
A0024405
17