Pressure Equipment Directive; Process Seal As Per Ansi/Isa 12.27.01; China Rohs Symbol; Rohs - Endress+Hauser Liquiphant FTL64 Technical Information

Liquiphant FTL64
Pressure Equipment
Directive
Process seal as per ANSI/ISA
12.27.01

China RoHS symbol

RoHS

Additional certification

ASME B 31.3

Endress+Hauser
Service
• Cleaned of oil+grease (wetted)
• Switching delay setting to be spec.
• Setting for MIN safety mode
• Default density setting > 0.4 g/cm
• Default density setting > 0.5 g/cm
Product documentation on paper
Hard-copy versions of the test reports, declarations and inspection certificates can also be ordered
via order code 570 "Service", option I7 "Hard-copy product documentation". The documents are then
provided with the device upon delivery.
Pressure equipment with allowable pressure ≤ 200 bar (2 900 psi)
Pressure instruments with a flange and threaded boss that do not have a pressurized housing do not
fall within the scope of the Pressure Equipment Directive, irrespective of the maximum allowable
pressure.
Reasons:
According to Article 2, point 5 of EU Directive 2014/68/EU, pressure accessories are defined as
"devices with an operational function and having pressure-bearing housings".
If a pressure instrument does not have a pressure-bearing housing (no identifiable pressure chamber
of its own), there is no pressure accessory present within the meaning of the Directive.
North American practice for the installation of process seals. In accordance with ANSI/ISA 12.27.01,
Endress+Hauser devices are designed as either single seal or dual seal devices with a warning
message. This allows the user to waive the use of - and save the cost of installing - an external
secondary process seal in the protective conduit as required in ANSI/NFPA 70 (NEC) and CSA 22.1
(CEC). These instruments comply with the North-American installation practice and provide a very
safe and cost-saving installation for pressurized applications with hazardous fluids. More
information is provided in the Safety Instructions (XA) for the relevant device.
Aluminum, stainless steel and plastic housing are approved as single-seal devices.
China RoHS 1, law SJ/T 11363-2006: The measuring system complies with the substance
restrictions of the Restriction on Hazardous Substances Directive (RoHS).
The measuring system complies with the substance restrictions of the Restriction on Hazardous
Substances Directive 2011/65/EU (RoHS 2).
EAC conformity
The measuring system meets the legal requirements of the applicable EAC guidelines. These are
listed in the corresponding EAC Declaration of Conformity together with the standards applied.
Endress+Hauser confirms successful testing of the device by affixing to it the EAC mark.
Design and materials in accordance with ASME B31.3. The welds are through-penetration welded
and meet the requirements of the ASME Boiler and Pressure Vessel Code, Section IX and EN ISO
15614-1.
3
3
41