Workplace Safety; Operational Safety; Product Safety - Endress+Hauser Cerabar PMP11 Operating Instructions Manual

Basic safety instructions
10
2.3

Workplace safety

For work on and with the device:
‣
Wear the required personal protective equipment according to federal/national
regulations.
‣
Switch off the supply voltage before connecting the device.
2.4

Operational safety

Risk of injury!
‣
Operate the device in proper technical condition and fail-safe condition only.
‣
The operator is responsible for interference-free operation of the device.
Conversions to the device
Unauthorized modifications to the device are not permitted and can lead to unforeseeable
dangers.
‣
If, despite this, modifications are required, consult with Endress+Hauser.
Hazardous area
To eliminate the risk of danger to persons or the facility when the device is used in the
approval-related area (e.g. explosion protection, pressure equipment safety):
‣
Check the nameplate to verify if the device ordered can be put to its intended use in the
approval-related area.
‣
Observe the specifications in the separate supplementary documentation, such as the
XA or SD, which is an integral part of these Instructions.
2.5

Product safety

This measuring device is designed in accordance with good engineering practice to meet
state-of-the-art safety requirements, has been tested, and left the factory in a condition in
which it is safe to operate.
It meets general safety standards and legal requirements. It also complies with the EC
directives listed in the device-specific EC Declaration of Conformity. Endress+Hauser
confirms this by affixing the CE mark to the device.
Cerabar PMP11, PMP21, PMP23
Endress+Hauser