Table of Contents
Advertisement
Product Description
2.2 Connections
2.2.1 Power Supply (X10)
The DVI Splitter will be powered by a 24 V
shown on the front panel of the CU8810-0010 device.
One 3-pole power supply connector is provided, the pin assignment is shown at the imprint beside the
connector. The low resistance protective earthing connection is established via the ground pin.
Malfunction possible with missing ground connection
A proper ground connection of the device is absolutely necessary for the correct
function of the touchscreen.
Note
2.2.2 Data Connectors
The CU8810-0010 has three kinds of connectors: USB type B, RJ45 and DVI. The pin layouts are
described below.
2.2.2.1
USB Typ B Port (X20) (standard cable)
Pin
Signal
1
VCC
2
Data -
3
Data+
2.2.2.2
RJ 45-Port (X30, X31, X32, X33) (standard CAT5 cable)
Pin
Signal
Assignment
1
15 V
15 V +
2
GND
GND
3
TX
USB TX
4
RX
USB RX
6
X10
power supply (X10). The pins have to be connected as
DC
X20
Connector USB TYP-B LP-mount. WS
X30, X31, X32, X33
BA 1x8pole RJ45 Invers shield 2XLWL Lp-mount. Molex Nr: 43860-0016 Modular Jack
Pin
Signal
4
GND
Shield
Shield
Pin
Signal
Assignment
5
RX
USB RX
6
TX
USB TX
7
15 V
15 V +
8
GND
GND
CU8810-0010
Advertisement
Table of Contents
