EN
SAFETY REGULATIONS
a wet cloth to wipe down the outside of the hose.
Lay the high-pressure hose in such a way as to ensure that
it cannot be tripped over.
Only use WAGNER original-high-pressure
hoses in order to ensure functionality, safety
and durability.
1.9
PERSONAL PROTECTION WHILE HOT SPRAYING
During all spraying with a temperature-set-
ting of more than 43°C (display on the control
panel starts blinking) take adequate safety
measures against combustion.
-> Wear protective gloves.
Attention: The high-pressure hose and the
hose whip are heated, too!
Use of a plastic coated spray gun is recom-
mended.
1.10
CLEANING THE UNIT
Danger of short-circuits caused by water in-
gression!
Never spray down the unit with high-pres-
sure or high-pressure steam cleaners.
1.11
CLEANING THE UNIT WITH SOLVENTS
When cleaning the unit with solvents, the
heating of the heating hose has to be switched
off, because an explosive gas/air-mixture can
emerge in the hose. The solvent should never
be sprayed or pumped back into a container
with a small opening (bunghole). An explo-
sive gas/air mixture can arise. The container
must be earthed.
1.12
WORK OR REPAIRS AT THE ELECTRICAL
EQUIPMENT
These may only be carried out by a skilled electrician. No li-
ability is assumed for incorrect installation.
1.13
WORK AT ELECTRICAL COMPONENTS
Unplug the power plug from the outlet before carrying out
any repair work.
24
TempSpray-H326 / -H226 / -H126
1.14
MAX. OPERATING PRESSURE
The permissible operating pressure for the spray gun, spray
gun accessories, unit accessories and high-pressure hose must
not fall short of the maximum operating pressure of
25 MPa (250 bar or 3625 psi).
1.15
SETTING
TempSpray-H326 and TempSpray-H226:
Position the heating-hose drum close to the spray-painting
device, without causing a risk of stumbling.
Do not use the heating-hose drum, if the power cord is de-
fect.
TempSpray-H126:
Assemble the governor housing to an adequate and suffi-
ciently fixed device connection.
Don't use the heating-hose, if the power cord is defect.