Safety Instructions; Environmental Protection; Important Note Regarding Product Liability - WAGNER DTS 5800 Manual

DTS 5800
Congratulations on purchasing your WAGNER spray guns.
Attention: When working with hot steam (approx.100°), there is a risk of serious scalding.
If you change position during use, be very careful because the steam unit,
hose and plate can be very hot. Always wear suitable protective clothing /
gloves.
Operate the unit only with pure water without agents or additives.Do not switch the unit
on when it is not fi lled with water.
Never point the steam plate / bar at people, animals or at objects sensitive to temperature.
Always ensure that the unit is standing securely in a horizontal position (on the
fl oor).
Do not stand on or place objects onto the unit or steam hose. Never over-twist or make
kinks in the steam hose, and never block the valve. Only carry the unit by its handle – and
in particular, never pull on the steam hose or mains cable.
Never submerge the unit in liquid. Every time the accessory is changed for, when fi lling/
refi lling and emptying or when the steam unit is not in use (including work pauses), pull
the mains plug out of the socket. Never overfi ll the unit. Unplug the mains plug in the
event of overfi lling or a fault.
Use only WAGNER original spare parts and accessories!
Caution! Danger of short-circuits! Cover sockets and switches and do not subject them
to steam.
When using an extension cable: max.10m long – the cable cross section must be at least
3 x 1 mm².
Avoid damage! When working in the vicinity of wood / gypsum bases and coated
materials these can be impaired by heat or steam. Remedy: Use a heat / steam shield
made of cardboard or metal. The unit switches off automatically in case of overheating.
After approx.12 minutes, the unit switches itself back on automatically.
The steam time is approximately 120 minutes. Never leave a unit unattended that is on.
Keep the unit away from children and animals. Never let the container steam until it is
completely empty.
Before loosening the screw connections always allow the unit cool down for at least
2 minutes. Caution! Risk of scalding!
Heated water can leak from the steam plate during the heating-up phase.
Hot water can drip during overhead work.
Store emptied, upright and dry.
Descale the steam wallpaper stripper after 40 - 50 hours of operation, depending on the
degree of hardness. Use a standard commercial descaling agent in accordance with the
manufacturer's instructions, or household vinegar.

Environmental protection

The appliance and accessories should be recycled in an environmentally
friendly way. Do not dispose of the appliance with household waste. Support
environmental protection by taking the appliance to a local collection point or
obtain information from a specialist retailer.

Important Note regarding Product Liability!

Due to an EC ordinance in eff ect since 01.01.1990, the manufacturer is liable for his

Safety instructions

GB
3