Danfoss VLT AQUA Drive FC 200 Operating Instructions Manual page 74

VLT AQUA Low Harmonic Drive Operating In-
structions
Navigation keys
The four navigation arrows are used to navigate between the different
choices available in [Quick Menu],
Use the keys to move the cursor.
[OK]
is used for choosing a parameter marked by the cursor and for enabling
the change of a parameter.
Operation keys
for local control are found at the bottom of the control panel.
[Hand on]
enables control of the frequency converter via the GLCP. [Hand on] also starts the motor, and it is now possible to give the motor speed reference by
means of the arrow keys. The key can be
The following control signals will still be active when [Hand on] is activated:
• [Hand on] - [Off] - [Auto on]
• Reset
• Coasting stop inverse (motor coasting to stop)
• Reversing
• Set-up select lsb - Set-up select msb
• Stop command from serial communication
• Quick stop
• DC brake
NB!
External stop signals activated by means of control signals or a serial bus will override a "start" command via the LCP.
[Off]
stops the connected motor (when pressed on the drive LCP) or the filter (when pressed on the filter LCP). The key can be
0-41 [Off] key on LCP. If no external stop function is selected and the [Off] key is inactive the motor can only be stopped by disconnecting the
via par.
mains supply.
[Auto on]
enables the frequency converter to be controlled via the control terminals and/or serial communication. When a start signal is applied on the control
terminals and/or the bus, the frequency converter will start. The key can be
[Main Menu] and [Alarm Log].
Enabled [1] or Disabled [0] via par. 0-40 [Hand on] Key on LCP.
®
MG.20.T1.02 - VLT is a registered Danfoss trademark
5 How to Operate the Low Harmonic Drive
Enabled [1] or Disabled [0] via par. 0-42 [Auto on] key on LCP.
5
130BP046.10
Enabled [1] or Disabled [0]
73