Danfoss VLT AQUA Drive FC 200 Operating Instructions Manual page 19

4 How to Install
4
Illustration 4.4: Recommended lifting method, frame size F - drive section.
NB!
Note the plinth is provided in the same packaging as the frequency converter but is not attached to frame size F during shipment. The
plinth is required to allow airflow to the drive to provide proper cooling. The F frames should be positioned on top of the plinth in the
final installation location. The angle from the top of the drive to the lifting cable should be 60° or greater.
In addition to the drawing above a spreader bar is an acceptable way to lift the F Frame.
NB!
The F size will be shipped as 2 pieces. Instructions on how to assemble the pieces can be found in the "Mechanical Installation" chapter.
18
VLT AQUA Low Harmonic Drive Operating In-
®
MG.20.T1.02 - VLT is a registered Danfoss trademark
structions