Danfoss VLT AQUA Drive FC 200 Operating Instructions Manual page 108

VLT AQUA Low Harmonic Drive Operating In-
structions
[105] Torque 0-Tnom
[106] Power 0-Pnom
[107] * Speed 0-HighLim
[113] Ext. Closed Loop 1
[114] Ext. Closed Loop 2
[115] Ext. Closed Loop 3
[130] Out frq 0-100 4-20mA
[131] Reference 4-20mA
[132] Feedback 4-20mA
[133] Motor cur. 4-20mA
[134] Torq.0-lim 4-20 mA
[135] Torq.0-nom 4-20mA
[136] Power 4-20mA
[137] Speed 4-20mA
[139] Bus ctrl.
[140] Bus ctrl. 4-20 mA
[141] Bus ctrl t.o.
[142] Bus ctrl t.o. 4-20mA
[143] Ext. CL 1 4-20mA
[144] Ext. CL 2 4-20mA
[145] Ext. CL 3 4-20mA
NB!
Values for setting the Minimum Reference is found in open loop par. 3-02
Feedb. - values for maximum reference for open loop is found in par. 3-03 Maximum Reference and for closed loop par. 20-14 Maximum Reference/
Feedb. .
6-51 Terminal 42 Output Min Scale
Range:
0.00 %* [0.00 - 200.00 %]
0 - Motor rated torque, (0-20 mA)
0 - Motor rated power, (0-20 mA)
Motor Speed High Limit [RPM] and par. 4-14 Motor Speed High Limit
0 - Speed High Limit (par. 4-13
[Hz] ), (0-20 mA)
0 - 100%, (0-20 mA)
0 - 100%, (0-20 mA)
0 - 100%, (0-20 mA)
0 - 100 Hz
Minimum Reference - Maximum Reference
-200% to +200% of par. 20-14 Maximum Reference/Feedb.
0 - Inverter Max. Current (par. 16-37
Torque Limit Motor Mode )
0 - Torque limit (par. 4-16
0 - Motor rated torque
0 - Motor rated power
0 - Speed High Limit (4-13 and 4-14)
0 - 100%, (0-20 mA)
0 - 100%
0 - 100%, (0-20 mA)
0 - 100%
0 - 100%
0 - 100%
0 - 100%
Minimum Reference and for closed loop par. 20-13 Minimum Reference/
Function:
Scale for the minimum output (0 or 4 mA) of the analogue signal at terminal 42.
Set the value to be the percentage of the full range of the variable selected in par. 6-50
42 Output .
®
MG.20.T1.02 - VLT is a registered Danfoss trademark
6 How to Programme the Low Harmonic Drive
Inv. Max. Current )
6
Terminal
107