Intel ® 82815E Graphics Memory Controller Hub (Gmch); Processor And Memory Module Combinations - Intel A67054-002 Product Manual

✏
NOTE
The BIOS cannot determine DIMM size or type when not initialized. If more than 512 MB system
memory is installed, the BIOS displays a message at boot indicating memory above 512 MB has
not been initialized. The message indicates that additional information is available in Setup. The
first time the BIOS detects this condition, a pause follows the message with the option to enter.
Setup or to <ESC> and continue to boot. The message continues to be displayed at boot time as
long as the condition exists, however, the BIOS will not pause on subsequent detection. Setup
displays the installed memory configuration and shows memory above 512 MB as
"not initialized."
The board supports the processor and memory module combinations shown in Table 3.
Table 3.

Processor and Memory Module Combinations

Processor Type (System Bus Frequency)
Intel Celeron processor (66 MHz)
Intel Celeron processor (100 MHz)
Intel Pentium III processor (100 MHz)
Intel Pentium III processor (133 MHz)
✏
NOTES
100 MHz system bus frequency processors will support 133 MHz memory; however, the memory
will operate at 100 MHz.
If more than four rows of 133 MHz SDRAM are populated, the BIOS will display a message
indicating that it will initialize installed memory up to 512 MB at 100 MHz.
®
Intel 82815E Graphics Memory Controller Hub (GMCH)
The GMCH provides the following:
•
An integrated Synchronous DRAM memory controller with autodetection of SDRAM.
•
Support for ACPI Rev 2.0 and APM Rev 1.2 compliant power management.
12
PC100 Memory Modules...
...will operate at 100 MHz
...will operate at 100 MHz
...will operate at 100 MHz
...will operate at 100 MHz
Intel Server Board S815EBM1 Product Guide
PC133 Memory Modules...
...will operate at 100 MHz
...will operate at 100 MHz
...will operate at 100 MHz
...will operate at 133 MHz