User Menu Screens - Vent-Axia Sentinel Kinetic Operation Manual

Operation and Monitoring

User Menu Screens

From the Normal Airflow screen, press the
Changing the value of a setting (if adjustable) is typically a 3-step procedure:
1. Press
2. Use the
more than 2 seconds.
3. Press
To return to the Normal Airflow screen, press the
seconds. Alternatively, the Normal Airflow screen will be restored if no buttons are pressed for two minutes
(timeout). Settings are stored in a the memory and will be retained in the event of mains power supply failure.
Low Airflow / Normal Airflow / Boost Airflow Screen
When the start-up screens are finished, the Low or
Normal screen is displayed showing operating status
(Low Airflow X % or Normal Airflow X % or Boost
Airflow X %).
The Normal screen displays the rate of normal airflow
(supply air) through the unit.
If the installation has proportional sensors or an internal
humidity sensor fitted, an
when they are boosting the airflow.
When the summer bypass is active, the normal screen
top line will alternate (for 3 seconds) with Summer
Bypass.
An interval can be set, see page 38 of the Installation
and Commissioning manual, at which the unit reminds
the user to check the filters. This will be 6, 12 or 18
months. The normal screen top line will include Check
Filter as a reminder to check and, if necessary, clean or
replace the filters.
When this has been done, press and hold the
buttons for 5 seconds to reset the automatic
message.
Sentinel Kinetic MVHR Operation & Monitoring
to select the setting (the setting will flash).
or buttons to adjust the value. To scroll quickly, press and hold the
again to enter the new settings and move to the next screen.
α
symbol will be displayed
button to access the rest of the User Menu screens.
button repeatedly or press and hold the
Normal Airflow
30 %
SUMMER BYPASS ON
30 %
Filter Service
Suburban
and
or buttons for
button for 5
9