Powering Up The Unit; Startup Screens - Vent-Axia Sentinel Kinetic Operation Manual

Starting Up

Powering Up the Unit

Switching On
To switch the unit on:
1. Switch on the power at the mains supply isolator feeding the unit.
2. Following switch-on, the fan motors will start and the Control Unit will display a series of startup screens,
described below.
Switching Off
To switch the unit off: at the unit's local isolator, turn the power off.

Startup Screens

Sentinel Kinetic Version Screen
The Sentinel Kinetic Version screen displays the
firmware version number for 3 seconds.
No adjustments are possible on this screen.
Language Screen
The Language screen displays the language used for
the screens. It is typically displayed for 5 seconds, or
longer if changing the setting.
Control Mode Screen
Selects between Control Mode 01 operation described
herein and the alternative Control Mode 02 described
in Appendix One.
Airflow Units Screen
The Airflow Units is a percentage of the unit's
maximum flow.
Wireless Control Screen
The Wireless Control screen automatically displays
whether the wireless boost control switch is fitted. It is
typically displayed for 3 seconds.
Humidity Sensor Screen
The Humidity Sensor screen displays whether the
humidity sensor is fitted. It is typically displayed for
3 seconds.
Sentinel Kinetic MVHR Operation & Monitoring
(The unit is designed to run continuously)
V--
Language
English
Control Mode
01
Airflow Units
%
Wireless Control
Not Fitted
Humidity Sensor
Not Fitted
7