Status Message Screens - Vent-Axia Sentinel Kinetic Operation Manual

Operation and Monitoring
Purge Screen
Pressing and holding the
activates purge mode when you want to purge air from
the building. The unit will revert to normal flow by
pressing and holding the
seconds. If the wireless boost option is fitted, this can
be triggered from the wireless transmitter/boost switch.
Purge mode runs the fans at full speed for 2 hours (120
minutes). The Purge screen displays a countdown of
the time remaining.
Cooker Hood Boost Screen
There is a separate connection for a cooker hood
control which allows the boost level to be higher when
triggered by a Cooker Hood.
Low Airflow Screen
Low Airflow mode is activated when the Normal Airflow
is set to Off, (see page 31 in the Installation and
Commissioning manual for set up details).
The Normal Airflow mode can be set to run during the
daytime i.e. from 6am to 11pm, the Low Airflow mode
will then run during the night from 11pm to 6pm.

Status Message Screens

The status message screens override the Normal Airflow and other user screens, and display status and key
operational conditions (temperatures or pressures, etc.) according to how the unit has been configured. If there
is more than one status item to be displayed, the highest priority message is shown.
These screens are displayed in a loop during normal operation of the unit, either after displaying the start-up
screens, or when commissioning has been completed. After a few seconds the display backlight is turned off in
order to minimise power consumption. The
to display individual screens for a longer period with the backlight turned on, if required.
Dryout Mode Screen
The Dryout Mode screen displays the time remaining
for the building to dry out. The unit runs at maximum
flow for 1 week.
Sentinel Kinetic MVHR Operation & Monitoring
button for 5 seconds
button again for 5
and buttons can be used to stop the loop sequence in order
Purge 120m
100 %
Cooker Hood
100 %
Low Airflow
20 %
Dryout Mode
168 h
12