Appendix One: Control Mode 02 Description; Overview; Airflow Mode Selection - Vent-Axia Sentinel Kinetic Operation Manual

Appendix One

Appendix One: Control Mode 02 Description

Overview

The functional differences described in this Appendix are available when Control Mode 02 is selected from the start-up
screens. Control Mode 02 assigns alternative functions to certain wiring Terminal Connections (described in Appendix
One of the Installation and Commissioning Manual) and allows additional airflow settings to be accessed via the
button on the front of the Kinetic unit or remote control as shown below:

Airflow Mode Selection

The following switching Functions are available via the
No. of presses
1
2
3
4
5
6
Press 10 seconds after last press to cancel and return to normal operation.
If the wireless boost option is fitted, this can be triggered from the wireless transmitter/boost switch.
If the installation has switch sensors, is wired to the lighting, has Vent-Wise sensors, Vent-Wise momentary switch or if
the internal time switch is set for periodic operation, operation will change from normal to boost automatically. Pressing
the button will reveal a code to show which device has activated boost.
s4 = Switch SW4
v1 = Vent-Wise Input S/W1
v2 = Vent-Wise Input S/W2
v3 = Vent-Wise Input S/W3
ls = Switched live (LS)
w1-4 = Wireless controller
c1-3 = Internal Time switch
If running on boost due to pressing the
when that device switches off. If a number of different devices are calling for boost flow, the unit will run at boost until the
last one has reverted to normal.
button with Control Mode 02:
Airflow Mode
(Control Mode 02)
Low
Normal
Boosts 30 minutes
Boosts 60 minutes
Boosts continuously
Cancel
button, another device may 'take over' the boost. Flow will return to normal