Table of Contents
Advertisement
Programming Commander DELTA
Menu item
Software / Stitch Counter
In Software mode, the bobbin
is monitored by the software
based on the number of stitches
sewn.
Operating Instructions D887 - 00.0 - 10/2022
Setting option 1
Counter Type
4 different counters can be applied.
The following 3 sub-items can be
set for each of the counters.
Counter value
Bobbin supply capacity in stitches.
This is a very variable value, which
depends on the size of the bobbin
and the thickness of the thread.
Sewing stop
Sewing stops and a notice is shown
on the display when the bobbin is
detected to be nearly empty. If the
parameter is not activated, only the
LEDs on the machine arm give a
warning if the bobbin is empty.
Sewing foot lower position
Reset necessary
It is only possible to resume sewing
after changing the bobbin and con-
firming the message on the control
panel.
Setting option 2
Value range
A/B/C/D
Value range
0 to 99999 [stitches]
Value range
On/Off
Value range
On/Off
Value range
On/Off
93
Advertisement
Table of Contents
