DURKOPP ADLER M-TYPE DELTA D887 Operating Instructions Manual page 197

Troubleshooting
Code Type
3224 Information Bobbin rotation monitor
3225 Information SSD sensor is soiled
3354 Information Failure in thread trimmer
3383 Information Failure in with the motor
4201 Warning
4430 Warning
4440 Disturbance OP3000: DAC receive
4441 Warning
4442 Warning
4443 Warning
4445 Disturbance OP3000: DAC send buffer
4446 Warning
4447 Warning
Operating Instructions D887 - 00.0 - 10/2022
Possible cause
process
referencing process
Failure SD-Card
OP3000: Connection lost
memory exceeded
OP3000: DAC receiver
timeout
OP3000: DAC unknown
message
OP3000: DAC invalid
checksum
exceeded
OP3000: DAC no response
OP3000: DAC invalid
response
Corrective
• The bobbin is not rotating
• Check the bobbin, advance the initial
thread
• Use compressed air or a soft cotton cloth
to clean the sensor
• Perform software update
• Check motor
• Perform software update
• Insert SD card
• Replace the control
• Check connection to OP3000
• Replace OP3000
• Replace the control
• Check connection to OP3000
• Replace OP3000
• Replace the control
• Check connection to OP3000
• Replace OP3000
• Replace the control
• Check connection to OP3000
• Replace OP3000
• Replace the control
• Check connection to OP3000
• Replace OP3000
• Replace the control
• Check connection to OP3000
• Replace OP3000
• Replace the control
• Check connection to OP3000
• Replace OP3000
• Replace the control
• Check connection to OP3000
• Replace OP3000
• Replace the control
195