116
5.8.3
Editing the segments of a seam
This section allows you to set the parameters for the current seam.
To edit the segments of a seam:
1.
Press on the desired seam.
The seam is highlighted in blue.
Fig. 68: Editing the segments of a seam (1)
2.
Press on the symbol
The interface used for setting the parameters opens.
Fig. 69: Editing the segments of a seam (2)
①
②
③
(1) - Managing segments
(2) - Parameters cross-segment
(3) - Parameters Segment
(4) - Parameters Segment End/
Seam End
Programming Commander DELTA
.
④
⑤
(5) - Parameters Segment Begin/
Seam Begin
(6) - List of adjustable parameters
Operating Instructions D887 - 00.0 - 10/2022
⑥