Table of Contents
Advertisement
Check the appliance is electrically safe and gas sound when you have nished.
Fig.8-30
Front left
Fig.8-31
Plinth
Pin
Locating
washer
Fig.8-33
Make sure the inner
rail is forwards
Fig.8-34
15 mm
Approx.
INSTALLATION
Final Fitting
Fitting the Bottom Panel
Open the left-hand oven door and make sure the storage
drawer is removed.
Note: For safety reasons make sure the drawer runners are
out of the way.
On the front on the cooker base there are two mounting
plates. Remove the three xing screws from each plate.
Front right
Fit the retaining brackets to the mounting plates and re t the
screws (Fig.8-30). DO NOT tighten at this stage.
Fig.8-32
Tilt the bottom of the panel slightly to locate the lower slots
onto the washers (Fig.8-31). Now rotate the panel to t over
the upper pins (Fig.8-32).
Using the two screws provided, secure the bottom panel onto
the brackets. DO NOT tighten at this stage.
Plinth
Adjust the bottom panel to align it with the door panels.
When it is positioned correctly, use a suitable at open ended
spanner to tighten the bracket screws, and then tighten the
bottom panel screws.
To Fit the Storage Drawer
Slide the inner side rails out until fully extended (Fig.8-33).
Lift the drawer at its sides and locate one of the drawer rails
(approximately 15 mm) onto an inner side rail (Fig.8-34).
Rotate the drawer to locate the remaining drawer rail onto
the opposite inner side rail.
Carefully slide the drawer back into the cavity. Some
resistance will be felt as the drawer rails locate fully onto the
inner side rails.
Customer Care
Installer: Please complete your details in this Guide, inform
the user how to operate the cooker and hand over the
instructions.
Thank you.
29
Advertisement
Table of Contents
