Fitting The Stability Chain; Levelling; Fitting The Hose - Rangemaster MCY 1200 Dual Fuel User's Manual & Installation Instructions

Table of Contents

Advertisement

Check the appliance is electrically safe and gas sound when you have nished.

Fitting the Stability Chain

Unless otherwise stated, a cooker using a exible gas
connector must be secured with a suitable stability device.
When using a stability chain (Fig.8-21) the chain should be
kept as short as is practicable and xed rmly to the rear of
the cooker, and to the wall with the supplied hook (Fig.8-22).
Repositioning the Cooker Following
Connection
If you need to move the cooker once it has been connected
then you need to unplug it and, having gripped under the
fascia panel and lifted the front of the cooker slightly
(Fig.8-23), you need to check behind the cooker to make sure
that the gas hose is not caught.
As you progress, make sure that both the electricity cable and
gas hose always have su cient slack to allow the cooker to
move.
With a stability chain tted, release it as you ease the cooker
out. Do not forget to re t it when you replace the cooker.
When you replace the cooker, again check behind to make
sure that the electricity cable and gas hose are not caught or
trapped.

Levelling

You are recommended to use a spirit level on a shelf in one of
the ovens to check for level.
Place the cooker in its intended position taking care not to
twist it within the gap between the kitchen units as damage
may occur to the cooker or the units.
The front feet and rear rollers can be adjusted to level the
cooker. To adjust the height of the rear of the cooker turn the
adjusting nuts at the front bottom corners of the cooker. To
set the front turn the feet bases to raise or lower.

Fitting the Hose

IMPORTANT: Suitable sealant MUST be used to seal
n
n
the hose and gas inlet pipe connection.
Apply suitable sealant to the threaded section of the gas
hose. Screw the hose into the gas inlet pipe on the rear of
the cooker (Fig.8-24). Screw in until tight. To avoid damage,
support the gas inlet pipe.
INSTALLATION
Fig.8-21
Stability chain
26
ArtNo.011-0006 - Chain to wall
ArtNo.010-0004 Moving the cooker
Fig.8-20
Fig.8-22
Fig.8-23
Fig.8-24

Advertisement

Table of Contents
loading

Table of Contents