Table of Contents
Advertisement
Check the appliance is electrically safe and gas sound when you have nished.
Fitting the Vent
The larger of the holes along the sides are for screwdriver
access and should face to the rear (Fig.8-10). Use the screws
and nuts supplied to hold the vent in place.
Conversion to Another Gas
If the appliance is to be converted to LP Gas do the
conversion at this point. See the 'Conversion' section of these
instructions and see the instructions in the conversion kit.
Fitting the Side Panels
1.
Fit the two rear side panel brackets onto the rear of the
cooker (Fig.8-11) and secure. Make sure the brackets
are correctly orientated.
2.
Located near the front on each side of the cooker there
are three screws – loosen the top and bottom screws
(Fig.8-12). Slide the obscuring trim onto the screws and
tighten to secure.
3.
Fit the side panel (Fig.8-13) using the following steps:
A.
On each side of the cooker are two side panel
locating slots. Fit the rear side panel tab (1) to the
rear cooktop slot (Fig.8-14), making sure to align
the rear slotted tab (4) to the ue slot.
B.
Slide the side panel bottom locating slot (2) onto
the rear bracket washer (Fig.8-15) and push back
(Fig.8-16).
C.
Locate the front panel side tab (3) to the front
cooktop slot (Fig.8-17).
D.
Make sure the rear slotted tab (4) locates properly
with the slot in the ue vent (Fig.8-18).
E.
With xing points (1) to (4) successfully located,
push the side panel backwards so that it touches
the rear ue.
Note: If a side panel is loose, t one of the extra
gaskets to the inner face of the front bracket
locating tabs (Fig.8-19) and re t.
4.
Using a suitable screwdriver, tighten the screw in the
vent to secure the side panel (Fig.8-20).
5.
Repeat for the other side panel.
INSTALLATION
Rear left
24
Note the position
of locating washer
Retaining
screws
Obscuring trim
Fig.8-9
Fig.8-10
Rear right
Fig.8-11
Fig.8-12
Advertisement
Table of Contents
