Table of Contents
Advertisement
For safety, push the grill tray back into the grill chamber.
If you need to remove the telescopic runners to allow
cleaning of the grill chamber, rst remove the grill tray then
you can unhook them from the grill chamber sides (Fig.6-8).
Wipe the sides clean with a soft cloth and mild detergent.
DO NOT put the side runners in a dishwasher.
Once you have nished, hook the side rails back onto the
sides of the chamber. Pull the telescopic rails out and t the
grill tray onto them, making sure to locate the cut-outs onto
the telescopic runner tabs (Fig.6-9).
Replace the grill pan.
Control Panel and Oven Doors
Avoid using any abrasive cleaners including cream cleaners.
For best results, use a liquid detergent.
The control panel and control knobs should only be cleaned
with a soft cloth wrung out in clean hot soapy water – but
take care that no surplus water seeps into the appliance. Wipe
with a clean dampened cloth then polish with a dry cloth.
The oven doors should only be cleaned with a soft cloth
wrung out in clean hot soapy water.
Ovens
'Cook & Clean' Panels
The ovens have side 'Cook & Clean' panels which have been
coated with a special enamel that partly cleans itself. This
does not stop all marks on the lining, but helps to reduce the
amount of manual cleaning needed.
These panels work better above 200 °C. If you do most of your
cooking below this temperature, occasionally remove the
panels and wipe with a lint free cloth and hot soapy water.
The panels should then be dried and replaced and the oven
heated at 200 °C for about one hour. This will make sure that
the panels are working e ectively.
Do not use steel wool (or any other materials that
n
n
will scratch the surface).
Do not use oven cleaning pads.
n
n
The Oven Shelf Supports
The shelf supports on the oven sides can be removed for
cleaning.
Removing the Oven Shelf Supports
Remove the oven shelves: Pull the top of the shelf support up
and away from the oven side and then lift the support away
from the locating bracket at the bottom of the oven side
(Fig.6-10).
Re tting the Oven Shelf Supports
To re t the side support: Locate the tag at the bottom of the
support into the slot in the locating bracket in the oven side
(Fig.6-11). Now locate the tops of the side arms in the holes
at the top and gently push down.
Grill pan
Telescopic rail
Grill tray
ArtNo.331-0005 Removing the grill rail
1
16
English
Fig.6-7
Telescopic rail
Fig.6-8
Fig.6-9
Fig.6-10
2
3
Advertisement
Table of Contents
