Electrical Connection; Final Checks; Final Fitting: 2-Piece Plinth; Customer Care - Rangemaster Professional Deluxe 100 Dual Fuel User's Manual & Installation Instructions

Check the appliance is electrically safe and gas sound when you have finished.
Current Operated Earth Leakage Breakers
The combined use of your cooker and other domestic
appliances may cause nuisance tripping, so we recommend
that the cooker is protected on an individual RCD (Residual
Current Device) or RCBO (Residual Current Breaker with
Overload).
IF IN DOUBT, PLEASE CONSULT A SUITABLY QUALIFIED
ELECTRICIAN.
Fig. 7.11
L
N
10 mm² max
ArtNo.130-0010 Electrical connections single-phase
230 V ac 50 Hz
Fig. 7.12
L1
N
L3
L2
6 mm² max
3N ac
230/400 V 50 Hz
Fig. 7.13
ArtNo.350-0010 - Fitting the plinth 1 (Kitchener)
Fig. 7.14
ArtNo.350-0011 - Fitting the plinth 2 (Kitchener)
Outer plinth xing screw
Inner plinth
INSTALLATION

Electrical Connection

The cooker must be installed by a qualified electrician, in
accordance with all relevant British Standards/Codes of
Practice (in particular BS 7671), or with the relevant national
and local regulations.
Note: The cooker must be connected to the correct electrical
supply as stated on the voltage label on the cooker, through
a suitable cooker control unit incorporating a double-pole
switch, having a contact separation of at least 3 mm in all
poles.
n
Access to the mains terminal is gained by removing the
electrical terminal cover box on the back panel. Connect
the mains cable to the correct terminals for your electrical
supply type (Fig. 7.11 and Fig. 7.12). Check that the links are
correctly fitted and that the terminal screws are tight. Secure
the mains cable using the cable clamp.
6 mm² max

Final Checks

Hotplate Check
Check each burner in turn (refer to the 'Hotplate Burners'
section at the front of the instructions).
Grill Check
Turn on the grill control and check that the grill heats up.
Oven Check
Set the clock, (refer to setting the clock section), turn on the
6 mm² max ovens. Check that the oven fans start to turn and heat up.
Turn off the oven.
Note: The oven light bulb is not included in the guarantee.
10 mm² max

Final Fitting: 2-piece Plinth

Fit the inner plinth to the bottom front of the cooker using
the 4 screws provided (Fig. 7.13).
Fit the outer plinth (2 screws, 1 each end) to the inner plinth.
The height of the outer plinth can be adjusted by sliding it up
or down via the slotted hole (Fig. 7.14).

Customer Care

Installer: Please complete your details in this guide, inform
the user how to operate the cooker and hand over the
instructions.
Thank you.
Outer plinth
26
The cooker MUST NOT be connected to an ordinary
n
domestic power point.