Execute The Application Program On The Wincon-8000 Platform - ICPDAS WinCon-8000 Getting Started

The .vcp file is not compatible with NMAKE. However, if your program uses a makefile
rather than a .vcp file, you can still build it in the development environment as an
external project.
To Build the Demo Application
1. On the "Build" menu, choose "Build Demo".
2. If you have finished the above steps, you would obtain the following message
in the Output window, which means the execution application has been built.
Otherwise, you will get error messages. You would then need to debug the
source code and rebuild the application.
3. If there no error messages are produced, you will find the Demo.exe file in
C:\Project\Demo\ARMV4Rel\.

5.1.6 Execute the Application Program on the Wincon-8000 Platform

When you have finished the building process for the Demo.exe, you
the developed execute file (Demo.exe) into the Wincon-8000 controller unit. For
example, you can use a portable memory stick (Like Pen Driver) to store the file and
to copy it to Wincon-8000. In a following section, we will develop a method for how to
download the application to the main controller unit through the Ethernet (TCP/IP) or
RS-232 series protocol. The main idea for running the user program within the
WinCon-8000 target control device is to make the process simple just like in the
following steps.
1. Copy the Demo.exe from C:\Project\Demo\ARMV4Rel\ subfolder to the
Wincon-8000.
2. Double-click on the Demo.exe file to run it on the Wincon-8000, as shown in
Fig. 5-1-19
WinCon-8000 Getting Start Manual-- 46
could apply