ICPDAS WinCon-8000 Getting Started page 13

3. When the Date/Time Properties dialog displays, set the date or current Time
and click the Apply button to set your system date and time.
Note: If you have changed any value of the date and time. You must save
the registry by means of WinCon Utility tools. For more information about
WinCon Utility tools, please refer to the WinCon Utility section.
Setup the network
Generally, most users don't need to setup the network because DHCP is the
default setting. However, if your network system does not contain a DHCP server, you
need to configure the network setting by using the manual method. The following
steps demonstrate the procedure for how to configure the network system.
1. Choose Start
Windows CE desktop to open this dialog.
2. Double click the LAN90001 icon to open the "LAN9000 Network Compatible
Adapter Settings" dialog.
3. When the "LAN9000 Network Compatible Adapter Settings" dialog displays
(see figure), click (enable) the "Specify an IP address" radio button in the IP
Address tab and type in the IP Address, Subnet Mask, and Default Gateway
into the respective fields.
4. Choose the "Name Servers" tab and also type in the Primary DNS,
Secondary DNS, Primary WINS, and Secondary WINS into the respective
fields, as shown in the figure below.
Settings Network and Dial_up Connections on the
Fig. 2-3
WinCon-8000 Getting Start Manual-- 13