ICPDAS WinCon-8000 Getting Started page 14

5. Click OK.
Note: If you have changed any value of network configuration, you must
save the registry by means of WinCon Utility tools. For more information
about the WinCon Utility tool, please refer to the WinCon Utility section.
Setting up the Device Name
You can configure Wincon-8000 to have the device name of your choice. To
change the device name please refer to the following steps:
1. Choose Start
2. Double click the System icon on the Control panel dialog to open the System
Properties.
3. When the System Properties dialog is displayed (see figure), select the
Device Name tab in the dialog window.
4. Type your preferred Device Name in the Device Name box, and click OK.
Fig. 2-4
Settings Control panel to open the Control panel dialog.
Fig. 2-5
WinCon-8000 Getting Start Manual-- 14