Test Setup - Viavi ComXpert CX100 Manual

2.0.4 Test Setup

2.0.4.1 Hardware Setup Diagram
Connect the CX100 and DUT as shown in
2.0.4.2 Configure the CX100 Receiver
In this example, the CX100 RF Receiver uses the following settings:
Rx Port
Rx Frequency
Rx External Attenuator
Reference level
Demodulation Type
IF Bandwidth
AF Filter
Low-Pass Corner Frequency
High-Pass Corner Frequency
De-Emphasis
To Configure the CX100 RF Receiver:
1. Power on the CX100.
2. Launch the RF Instrument application on the CX100.
22144016
October 2022
Figure 2-1 FM Transmitter Test Setup Diagram
Table 2-2 FM Transmitter Test - RF Receiver Settings
Parameter
CX100 ComXpert Test and Measurement Guide
Chapter 2 Performing FM Transmitter Tests
Figure 2-1, then proceed to the next section.
Setting
DUPLEX
151.100000 MHz
0.0 dB
37.0 dBm
FM
12.5 kHz
Band-Pass
300 Hz
3 kHz
µs
0
Rev 000
2 - 3