Emerson Rosemount 702 Quick Start Manual page 11

Wireless discrete transmitter

Hide thumbs Also See for Rosemount 702:

July 2023

Procedure

1. Install the switch according to standard installation practices

making sure to use thread sealant on all connections.

2. Run wiring (and conduit if necessary) from the switch to the

Rosemount 702 Wireless Discrete Transmitter.

3. Pull the wiring through the threaded conduit entry of the

transmitter.

4. Referring to the wiring diagram (see

wiring switch inputs, output circuits, and leak

the switch wiring to the terminals.

5. Connect the power module.

Note

Power up the wireless devices in order of proximity from

the Wireless Gateway, beginning with the closest device to

the gateway. This will result in a simpler and faster network

formation.

Note

Always ensure a proper seal so the metal touches metal, but do not

overtighten.

6. Close the housing cover and tighten to safety specification.

7. Position antenna vertically, either straight up or straight down.

Position the antenna approximately 3 ft. (0.91 m) from any

large structures or buildings to allow clear communication

with other devices.

Quick Start Guide

Reference information:

sensors), attach

Table of Contents