Table of Contents
Advertisement
2. IMPORTANT REQUIREMENTS
• Use only original and new parts to guarantee the reliability, optimization, and
performance of the OASIS water machine.
• Always wear proper protection when performing any type of service or
maintenance.
• When cleaning the unit, do not use corrosive acidic products, or metal
brushes.
• Do not wash the unit using high-pressure water.
• Connect to a water supply with a pressure of 45 PSI minimum to 100 PSI
maximum (3.10 bar minimum to 6.89 bar maximum ).
• WARNING: DO NOT USE WITH WATER THAT IS MICROBIOLOGICALLY UNSAFE
OR OF UNKNOWN QUALITY.
• ATTENTION: IT IS IMPORTANT TO MAKE PROPER CONNECTIONS TO THE
QUICK CONNECT FITTINGS TO AVOID LEAKS. SEE SECTION 5.
• CAUTION: DO NOT PLACE UNDUE STRESS OR SIDE LOAD ON ANY OF THE
PLASTIC FITTINGS.
• CAUTION: DO NOT ACTIVATE ELECTRICAL EYE SENSOR WITHOUT RUNNING
WATER THROUGH THE UVC MODULE. DOING SO WILL DAMAGE THE UV-C
LEDS. SEE SECTION 4, STEP 2e, and SECTION 7, STEPS 13 - 18.
3. SAFETY WARNINGS:
BEFORE YOU START USING THIS WATER DISPENSER, PLEASE READ THE
FOLLOWING INSTRUCTIONS CAREFULLY.
• The unit must be connected to a 115 VAC GFCI or 230VAC power supply as
listed on the equipment data label.
• The unit must be protected by a properly installed 20 amp circuit breaker.
Verify that the electrical current is correct for the power of this unit, which is
listed on the machine data label.
• To avoid electrical shock always unplug the unit from the electrical outlet
before servicing.
• If the power supply cord is damaged, it must be replaced by a special cord or
assembly available from the manufacturer or its service agent.
• This appliance must be earthed.
• Children should be supervised to ensure that they do not play with this
appliance.
4
Advertisement
Table of Contents
