Table of Contents
Advertisement
4. QUASAR UV-C LED OPERATION
1.
QUASAR is a form of dispense point water treatment that utilizes UV-C
LED's to inactivate pathogens.
2.
Operation:
a.
The QUASAR activation is automatic. The UV-C LED's turn ON when
water is dispensed and OFF when the dispense stops.
b.
During non-use periods the QUASAR automatically cycles ON for
ten seconds every ten minutes. This keeps the dispense point more
sanitary between use.
c.
When the QUASAR is ON, the LED light on the front of the alcove
near the top will turn ON. The LED will be BLUE when the QUASAR
is working properly.
d.
If QUASAR is not working properly, then the LED light on the front
of the alcove near the top will be ORANGE. The light will remain ON
and the system will not allow water to be dispensed until the
problem is resolved unless "Override Stop Dispense" is selected in
the program menu. See "SET-UP GUIDE FOR QUASAR PCB
ELECTRONICS" for instructions on how to change this setting.
IMPORTANT: Never operate the QUASAR without water connected
e.
to the system. Lack of water can cause the QUASAR to overheat. If it
is necessary to activate QUASAR to purge the system of air, then do
not activate the QUASAR dry for more than 4-5 seconds at a time.
Wait 60 seconds to allow the QUASAR to "cool" before the next
"dry" activation. Dry activations normally occur during initial setup
or during filter changes.
5
Advertisement
Table of Contents
