SOLTEK KT333A Manual page 66

KT333A / KT333A-L
Configure SDRAM
Timing by SPD
SDRAM Frequency Allows you to set the SDRAM frequency.
SDRAM CAS# Latency With SDRAM Timing by SPD disabled, you can se-
SDRAM Bank Inter-
leave
SDRAM Burst Length With SDRAM Timing by SPD disabled, you can se-
SDRAM Command
Rate
AGP Mode Allows you to see the AGP Mode on board.
AGP Comp. Driving Allows you to see the AGP Compensation Driving .
Manual AGP Comp.
Driving
AGP Fast Write Allows you to enable / disable the AGP Fast Write
SPD (Serial presence detect) is a device in memory
module for storing the module information such as
DRAM timing and chip parameters. If this option is
enabled, BIOS will access SPD automatically to
configure module timing. If disabled, DRAM timing
can be configured manually.
Choices: Auto(default); 200MHz; 266MHz; 333MHz
lect the SDRAM CAS# (Column Address Strode)la-
tency manually.
Choices: 2Clocks; 2.5 Clocks(default)
This item allows you to enable / disable SDRAM
Bank Interleave function.
Choices: Disabled (default); 2-way; 4-way
lect the SDRAM Burst length manually.
Choices: 8 QW; 4 QW
Allows you to set the SDRAM Command Rate.
Choices: 1T; 2T
Choices: 4X; 2X; 1X
Choices: Auto; Manual
If AGP Comp. Driving is set to "Manual", use this
item to set the compensation Driving address.
Choices: CB (default); 00~FF
function
68